

- UC282TDTR-1 - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - 线性
- MSP430G2533IN20 - 集成电路(IC) > 嵌入式 > 微控制器
- SN74CBT16210DGGR - 集成电路(IC) > 逻辑 > 信号开关,多路复用器,解码器
- DS100BR210EVK/NOPB - 开发板,套件,编程器 > 评估板 > 评估和演示板及套件
- LM5035CMH/NOPB - 集成电路(IC) > 电源管理(PMIC) > DC-DC 开关控制器
- SN74BCT2827CNS - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- TLC4545ID - 集成电路(IC) > 数据采集 > 模数转换器(ADC)
- BQ2057SN - 集成电路(IC) > 电源管理(PMIC) > 电池充电器
- CY74FCT2245TSOC - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- SN74HC574ANSR - 集成电路(IC) > 逻辑 > 触发器
- OPA455EVM - 开发板,套件,编程器 > 评估板 > 运算放大器评估板
- SN75116NS - 集成电路(IC) > 逻辑 > 缓冲器,驱动器,接收器,收发器
- LM3S9L71-IQC80-C3 - 嵌入式 - 微控制器
- TLC27L2CPS - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- MSP430G2152IPW14 - 集成电路(IC) > 嵌入式 > 微控制器
- INA296A5IDGKR - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- SN74LV165ADRG4 - 集成电路(IC) > 逻辑 > 移位寄存器
- LMR23630FDRRR - 集成电路(IC) > 电源管理(PMIC) > 稳压器 - DC-DC 开关稳压器
- TLV2451AID - 集成电路(IC) > 线性 > 放大器 > 仪器,运算放大器,缓冲器
- SN65EPT23DR - 集成电路(IC) > 逻辑 > 转换器,电平移位器



LM5025B - 有源钳位电压模式 PWM 控制器
LM5025B是TI德州仪器公司的一款PWM与谐振控制器产品,LM5025B是有源钳位电压模式 PWM 控制器,本站介绍了LM5025B的封装应用图解、特点和优点、功能等,并给出了与LM5025B相关的TI元器件型号供参考。
LM5025B - 有源钳位电压模式 PWM 控制器 - PWM与谐振控制器 - 离线隔离型DC/DC控制器和转换器 - 德州仪器
The LM5025B is a functional variant of the LM5025 active clamp PWM controller. The functional differences of the LM5025B are as follows:
The maximum PWM duty cycle is limited to less than 75% to reduce voltage stress on the power MOSFETs. The CS2 hiccup mode threshold is increased to 0.5V The CS2 filter discharge device is disabled The VCC regulator continues to operate when the line UVLO is below the threshold of normal operation The VREF regulator is switched off when the line UVLO input falls below the operating threshold The internal 5k? COMP pin pull-up resistor is removedThe LM5025B PWM controller contains all of the features necessary to implement power converters utilizing the Active Clamp / Reset technique. With the active clamp technique, higher efficiencies and greater power densities can be realized compared to conventional catch winding or RDC clamp / reset techniques. Two control outputs are provided, the main power switch control (OUT_A) and the active clamp switch control (OUT_B). The two internal compound gate drivers parallel both MOS and Bipolar devices, providing superior gate drive characteristics. This controller is designed for high-speed operation including an oscillator frequency range up to 1MHz and total PWM and current sense propagation delays less than 100ns.
The LM5025B includes a high-voltage start-up regulator that operates over a wide input range of 13V to 100V. Additional features include: Line Under Voltage Lockout (UVLO), softstart, oscillator UP/DOWN sync capability, precision reference and thermal shutdown.
- Internal Start-Up Bias Regulator
- 3A Compound Main Gate Driver
- Programmable Line Under-Voltage Lockout (UVLO) with Adjustable Hysteresis
- Voltage Mode Control with Feed-Forward
- Adjustable Dual Mode Over-Current Protection
- Programmable Overlap or Deadtime between the Main and Active Clamp Outputs
- Volt x Second Maximum Duty Cycle Clamp
- Programmable Soft-Start
- Current Sense Leading Edge Blanking
- Single Resistor Programmable Oscillator
- Oscillator Up / Down Sync Capability
- Precision 5V Reference
- Thermal Shutdown
Packages
- TSSOP-16
- WSON-16 (5x5 mm) Thermally Enhanced
- TPA4861 - 1W 单声道音频功率放大器
- TPS73HD301 - 双输出 LDO 稳压器
- LMP92064 - LMP92064 Precision Low-Side, Digital Current Sensor & Voltage Monitor
- MCP809 - 3 引脚微处理器重置电路
- SN65LBC176A - 差动总线收发器
- SN54HCT74 - 具有清零和预设功能的双路 D 类上升沿触发器
- CD4002B-MIL - CMOS 双路 4 输入或非门
- TS3DDR3812 - 用于 DDR3 应用的 12 通道、1:2 MUX/DEMUX 开关
- SN74AUP1T14 - 低功耗、1.8/2.5/3.3V 输入、3.3V CMOS 输出、单路施密特触发反向器闸
- LMX2531 - 具有集成 VCO 的高性能频率合成器系统



