MAX211是TI公司的一款无产品,MAX211是具有 ?15kV ESD 保护的 5V 多通道 RS-232 线路驱动器/接收器,本页介绍了MAX211的产品说明、应用、特性等,并给出了与MAX211相关的TI元器件型号供参考。
MAX211 - 具有 ?15kV ESD 保护的 5V 多通道 RS-232 线路驱动器/接收器 - 无 - RS-232收发器 - TI公司(Texas Instruments,德州仪器)
The MAX211 device consists of four line drivers, five line receivers, and a dual charge-pump circuit with ±15-kV ESD protection pin to pin (serial-port connection pins, including GND). The device meets the requirements of TIA/EIA-232-F and provides the electrical interface between an asynchronous communication controller and the serial-port connector. The charge pump and four small external capacitors allow operation from a single 5-V supply. The devices operate at data signaling rates up to 120 kbit/s and a maximum of 30-V/µs driver output slew rate.
The MAX211 has both shutdown (SHDN) and enable control (EN)\. In shutdown mode, the charge pumps are turned off, V+ is pulled down to VCC, V is pulled to GND, and the transmitter outputs are disabled. This reduces supply current typically to 1 µA. EN\ is used to put the receiver outputs into the high-impedance state to allow wired-OR connection of two RS-232 ports. It has no effect on the RS-232 drivers or the charge pumps.
- RS-232 Bus-Pin ESD Protection Exceeds ±15 kV Using Human-Body Model (HBM)
- Meets or Exceeds the Requirements of TIA/EIA-232-F and ITU v.28 Standards
- Operates at 5-V VCC Supply
- Four Drivers and Five Receivers
- Operates Up To 120 kbit/s
- Low Supply Current in Shutdown Mode... 1 µA Typical
- External Capacitors... 4 × 0.1 µF
- Latch-Up Performance Exceeds 100 mA Per JESD 78, Class II
- Applications
- Battery-Powered Systems, PDAs, Notebooks, Laptops, Palmtop PCs, and Hand-Held Equipment