MSP430F5514是TI公司的一款低功耗高性能产品，MSP430F5514是16 位超低功耗微处理器，具有 USB 接口、64KB 闪存、4KB RAM、2 个 USCI、32 位 HW MPY，本页介绍了MSP430F5514的产品说明、应用、特性等，并给出了与MSP430F5514相关的TI元器件型号供参考。
MSP430F5514 - 16 位超低功耗微处理器，具有 USB 接口、64KB 闪存、4KB RAM、2 个 USCI、32 位 HW MPY - 低功耗高性能 - 低功耗MCU - TI公司（Texas Instruments，德州仪器）
- Low Supply Voltage Range: 3.6 V Down to 1.8 V
- Ultra-Low Power Consumption
- Active Mode (AM):
- All System Clocks Active:
- 290 µA/MHz at 8 MHz, 3.0 V, Flash Program Execution (Typical)
- 150 µA/MHz at 8 MHz, 3.0 V, RAM Program Execution (Typical)
- All System Clocks Active:
- Standby Mode (LPM3):
- Real-Time Clock (RTC) With Crystal, Watchdog, and Supply Supervisor Operational, Full RAM Retention, Fast Wake up:
- 1.9 µA at 2.2 V, 2.1 µA at 3.0 V (Typical)
- Low-Power Oscillator (VLO), General-Purpose Counter, Watchdog, and Supply Supervisor Operational, Full RAM Retention, Fast Wake up:
- 1.4 µA at 3.0 V (Typical)
- Real-Time Clock (RTC) With Crystal, Watchdog, and Supply Supervisor Operational, Full RAM Retention, Fast Wake up:
- Off Mode (LPM4):
- Full RAM Retention, Supply Supervisor Operational, Fast Wake up:
- 1.1 µA at 3.0 V (Typical)
- Full RAM Retention, Supply Supervisor Operational, Fast Wake up:
- Shutdown Mode (LPM4.5):
- 0.18 µA at 3.0 V (Typical)
- Active Mode (AM):
- Wake up From Standby Mode in 3.5µs (Typical)
- 16-Bit RISC Architecture, Extended Memory, up to 25-MHz System Clock
- Flexible Power Management System
- Fully Integrated LDO With Programmable Regulated Core Supply Voltage
- Supply Voltage Supervision, Monitoring, and Brownout
- Unified Clock System
- FLL Control Loop for Frequency Stabilization
- Low-Power Low-Frequency Internal Clock Source (VLO)
- Low-Frequency Trimmed Internal Reference Source (REFO)
- 32-kHz Watch Crystals (XT1)
- High-Frequency Crystals up to 32 MHz (XT2)
- 16-Bit Timer TA0, Timer_A With Five Capture/Compare Registers
- 16-Bit Timer TA1, Timer_A With Three Capture/Compare Registers
- 16-Bit Timer TA2, Timer_A With Three Capture/Compare Registers
- 16-Bit Timer TB0, Timer_B With Seven Capture/Compare Shadow Registers
- Two Universal Serial Communication Interfaces
- USCI_A0 and USCI_A1 Each Support:
- Enhanced UART Supports Automatic Baud-Rate Detection
- IrDA Encoder and Decoder
- Synchronous SPI
- USCI_B0 and USCI_B1 Each Support:
- I2C
- Synchronous SPI
- USCI_A0 and USCI_A1 Each Support:
- Full-Speed Universal Serial Bus (USB)
- Integrated USB-PHY
- Integrated 3.3-V and 1.8-V USB Power System
- Integrated USB-PLL
- Eight Input and Eight Output Endpoints
- 12-Bit Analog-to-Digital Converter (ADC) (MSP430F552x Only) With Internal Reference, Sample-and-Hold, and Autoscan Feature
- Comparator
- Hardware Multiplier Supports 32-Bit Operations
- Serial Onboard Programming, No External Programming Voltage Needed
- Three-Channel Internal DMA
- Basic Timer With RTC Feature
- Section 3 Summarizes Available Family Members
- For Complete Module Descriptions, See the MSP430x5xx and MSP430x6xx Family User's Guide (SLAU208)
- Analog and Digital Sensor Systems
- Data Loggers
- Connection to USB Hosts
The TI MSP430™ family of ultra-low-power microcontrollers consists of several devices featuring peripheral sets targeted for a variety of applications. The architecture, combined with extensive low-power modes, is optimized to achieve extended battery life in portable measurement applications. The microcontroller features a powerful 16-bit RISC CPU, 16-bit registers, and constant generators that contribute to maximum code efficiency. The digitally controlled oscillator (DCO) allows the devices to wake up from low-power modes to active mode in 3.5 µs (typical).
The MSP430F5529, MSP430F5527, MSP430F5525, and MSP430F5521 microcontrollers have integrated USB and PHY supporting USB 2.0, four 16-bit timers, a high-performance 12-bit analog-to-digital converter (ADC), two universal serial communication interfaces (USCI), a hardware multiplier, DMA, a real-time clock (RTC) module with alarm capabilities, and 63I/O pins. The MSP430F5528, MSP430F5526, MSP430F5524, and MSP430F5522 microcontrollers include all of these peripherals but have 47 I/O pins.
The MSP430F5519, MSP430F5517, and MSP430F5515 microcontrollers have integrated USB and PHY supporting USB 2.0, four 16-bit timers, two universal serial communication interfaces (USCI), a hardware multiplier, DMA, an RTC module with alarm capabilities, and 63I/O pins. The MSP430F5514 and MSP430FF5513 microcontrollers include all of these peripherals but have 47 I/O pins.
Typical applications include analog and digital sensor systems, data loggers, and others that require connectivity to various USB hosts.
| PART NUMBER | PACKAGE | BODY SIZE(2) |
|---|---|---|
| MSP430F5529PN | LQFP (80) | 12 mm × 12 mm |
| MSP430F5528RGC | VQFN (64) | 9 mm × 9 mm |
| MSP430F5528YFF | DSBGA (64) | 3.5 mm × 3.5 mm |
| MSP430F5528ZQE | MicroStar Junior™ BGA (80) | 5 mm × 5 mm |
