TPS43340-Q1是TI公司的一款无产品,TPS43340-Q1是汽车类低 Iq 30uA、高输入电压、四路输出电源,本页介绍了TPS43340-Q1的产品说明、应用、特性等,并给出了与TPS43340-Q1相关的TI元器件型号供参考。
TPS43340-Q1 - 汽车类低 Iq 30uA、高输入电压、四路输出电源 - 无 - 电源管理多通道IC(PMIC)解决方案 - TI公司(Texas Instruments,德州仪器)
- Qualified for Automotive Applications
- AEC-Q100 Test Guidance With the Following Results:
- Device Temperature Grade 1: –40°C to 125°C Ambient Operating Temperature
- Device HBM ESD Classification Level H1C
- Device CDM ESD Classification Level C3B
- Input Range up to 40 V, (Transients up to 60 V)
- Input Voltage Range: 4 V to 40 V
- Transients up to 60 V
- Dual-Output Synchronous Buck Controller
- Peak Gate Drive Current 0.6 A
- Automatic Low-Power Mode Operation
- Low-Power-Mode IQ : 30 µA (One Buck On), 35 µA (Two Bucks On)
- Low Shutdown Current, Ish = 5 μA Typical
- Single Synchronous Buck Regulator Converter BUCK3
- Max Output Current 2 A
- Linear Regulator LREG1
- Separate Enable Inputs (EN1, EN2, EN3, EN4)
- Internal Oscillator, Programmable via External Resistor, 150 kHz to 600 kHz for Switching Frequency fSW_BUCK1,2,3
- Integrated PLL, External Synchronization Frequency: 150 kHz to 600 kHz
- Switch-Mode Regulators Operate With 180° Phase-Shift
- Reset Output for All Output Rails
- Supply and Overvoltage Detection and Shutdown
- Thermally Enhanced PowerPAD™ Package
- 48-Pin HTQFP (PHP)
- Automotive Infotainment, Head Unit, Navigation, Audio and Clusters
- Advanced Driver Assistance System (ADAS)
- Automotive and Industrial Multi-Rail DC Power Distribution Systems
The TPS43340-Q1 is a quad rail power supply featuring two synchronous Buck Controller with 0.6-A gate drive, one synchronous 2-A Buck Converter and a 300-mA LDO with low quiescent current. The device is designed to power the entire system including MCU and DSP straight from the car battery respectively input voltages up to 40 V. The device features integrated short-circuit and overcurrent protection on the gate-drive outputs for the buck regulator controllers and independent current-foldback control for each buck regulator supply during regulator output short to ground. Each output supply incorporates a soft start to ensure that on initial power up these regulated outputs are not in current limit. Implementation of reset delay on power up allows the outputs of Buck1, Buck2, Buck3 and the linear regulator to get to stable regulation. An external capacitor sets the delay to a maximum range of 300 ms. Each power-supply output has adjustable output voltage based on the external resistor-network settings. The device has sequencing control during power up and power down of the output rails, based on the enable-and-disable control or soft start.
PART NUMBER | PACKAGE | BODY SIZE (NOM) |
---|---|---|
TPS43340-Q1 | HTQFP (48) | 7.00 mm × 7.00 mm |